臭氧对有机物混凝的影响

采用PDA(Photometric Disperse Analysis)和有机物表观分子量分级、有机物化学极性分级技术从絮体形成过程、絮体表现、有机物分子水平变化等方面研究了臭氧预氧化对混凝过程的影响;并对比了不同混凝剂在预臭氧条件下的混凝过程和效率.结果表明:臭氧预氧化对混凝过程有复杂的影响,其剂量和水体有机物特征决定了其对混凝的整体影响效果.有机物分级显示,臭氧化对有机物结构有重要影响,导致有机物极性、亲水性组分含量大幅提高(36.7%),小分子量组分(<10×10³)大幅增高(100%左右);但总的DOC去除率不高(3.28%).对PACl而言,在中、低剂量(O₃/TOC<0.7)下,臭氧对絮体形成过程影响较小,但对絮体沉降性和浊度去除已经有阻碍作用.在中、高剂量下(O₃/TOC>0.7),对絮体形成有显著滞后,浊度、有机物去除效率下降.AlCl₃对臭氧化作用反应敏感,臭氧化在试验剂量条件下,对絮体形成和浊度、有机物去除都有明显的阻碍作用.     

游离羟基及表面活性剂对乙草胺光解的影响

以高压汞灯为光源,以p-亚硝基-N,N-二甲基苯胺(PNDA)作为·OH自由基的探针,研究了H2O2及表面活性剂0206-B(苯乙烯苯酚聚氧乙烯醚和十二烷基苯磺酸钙混剂)对除草剂乙草胺在水中间接光解作用的影响.结果表明,H2O2对水中乙草胺具有光敏化降解作用,其敏化作用效应与·OH有关;而0206-B对乙草胺具有光猝灭降解作用,光猝灭降解作用效应与0206-B减少水溶液中的·OH自由基含量有关.乙草胺直接光解与H2O2作用的乙草胺间接光解相同的产物有Rf(比移值)为0.12、0.52、0.61、0.72的化合物;H2O2敏化降解抑制了乙草胺直接光解产物Rf为0.04、0.10、0.18、0.21、0.79的化合物产生,但促进乙草胺间接光解Rf为0.45、0.66的新光解产物生成.     

Enhanced photocatalysis of pentachlorophenol by metal-modified titanium (IV) oxide

The effects of four metals (Ag, Au, Pt, and Cu) doped on TiO2 on the photocatalysis of pentachlorophenol (PCP) were investigated. The results of this study indicated that all four metals-doped TiO2 catalysts were able to enhance the efficiency of PCP photocatalysis with an optimum metallic content of 0.1 wt%. For the metal-doped TiO2 samples (Au, Pt, and Cu), the patterns of light absorption were significantly extended toward visible light spectra in the wavelengths between 400 and 800 nm. The photocatalysis of PCP was pH dependent with the maximum degradation rate achieved in the solution at pH 3. The formation of chloride ion corresponded with the concentration of PCP degraded which confirmed that dechlorination was the major pathway of PCP photocatalysis. The overall toxicities of PCP samples were reduced with the extension of light exposure using the microtox test. The results of PCP photocatalysis are also discussed based on the characteristics of metal/TiO2 including X-ray differential (XRD) patterns, Brunquer Emmett Teller (BET) specific area analysis, and Ultra Violet (UV)-Vis absorption spectra.     

Adsorption characteristics of benzene on biosolid adsorbent and commercial activated carbons

This study selected biosolids from a petrochemical waste-water treatment plant as the raw material. The sludge was immersed in 0.5-5 M of zinc chloride (ZnCl2) solutions and pyrolyzed at different temperatures and times. Results indicated that the 1-M ZnCl2-immersed biosolids pyrolyzed at 500 degrees C for 30 min could be reused and were optimal biosolid adsorbents for benzene adsorption. Pore volume distribution analysis indicated that the mesopore contributed more than the macropore and micropore in the biosolid adsorbent. The benzene adsorption capacity of the biosolid adsorbent was 65 and 55% of the G206 (granular-activated carbon) and BPL (coal-based activated carbon; Calgon, Carbon Corp.) activated carbons, respectively. Data from the adsorption and desorption cycles indicated that the benzene adsorption capacity of the biosolid adsorbent was insignificantly reduced compared with the first-run capacity of the adsorbent; therefore, the biosolid adsorbent could be reused as a commercial adsorbent, although its production cost is high.     

Pozzolanic reactivity of the synthetic slag from municipal solid waste incinerator cyclone ash and scrubber ash

This study investigates the pozzolanic reactions and compressive strength of the blended cement manufactured using synthetic slag obtained from municipal solid waste incinerator (MSWI) cyclone ash and scrubber ash as partial replacement of portland cement. The synthetic slag was made by co-melting the MSWI scrubber ash and cyclone ash mixtures at 1400 degrees C for 30 min. Following pulverization, the different types of slag were blended with cement as cement replacement at ratios ranging from 10 to 40 wt %. The synthetic slag thus obtained was quantified, and the characteristics of the slag-blended cement pastes were examined. These characteristics included the pozzolanic activity, compressive strength, hydration activity, crystal phases, species, and microstructure at various ages. The 90-day compressive strength developed by slag-blended cement pastes with 10 and 20 wt % of the cement replaced by the synthetic slag outperformed ordinary portland cement by 1-7 MPa. X-ray diffraction species analyses indicated that the hydrates in the slag-blended cement pastes were mainly portlandite, the calcium silicate hydrate gels, and calcium aluminate hydrate salts, similar to those found in ordinary portland cement paste. Differential thermal and thermogravimetric analysis also indicated that the slag reacted with portlandite to form calcium silicate hydrate gels.     

泥石流-堰塞湖灾后应急救援决策研究——以甘肃文县“8·17”泥石流灾害为例

以甘肃文县2020年"8.17"泥石流灾害为例,开展泥石流-堰塞湖灾害灾后应急救援决策研究,探索性将该类灾害前期阶段应急救援决策总结为:灾情盲估预判-先期应急备灾-成因剖析-灾情宏观初判-应急救援决策等。研究结果表明:预判影响人口约10.8万人,预估需求帐篷约2.3万顶、饮用水约240 t/d,文县消防救援大队距离最近,附近有文县第一人民医院等8家医疗防疫力量,石鸡坝初级中学等10所学校可作为临时安置避难场所备选;受影响矿山企业5家,重要水库1座;泥石流淤积物堆积区约7.91×10~4 m~2,堰塞湖面积约1.06 km~2,淹没区约37.4×10~4 m~2,因灾受损民居51处、桥梁3处、电站1处、加油站1处及耕地10处,优选3条灾后救援生命线。     

生物滴滤塔脱除污泥干化尾气中的SO2

以市政污泥干化尾气中的主要含硫物质二氧化硫(SO2)为处理对象,从市政污泥中筛选出高效脱硫菌——嗜酸性氧化亚铁硫杆菌(Acidithiobacillus ferrooxidans,A.f),搭建了实验室规模的生物滴滤塔,考察了进气质量浓度、气体停留时间、营养液喷淋密度和营养液中Fe2+浓度对生物滴滤塔脱除SO2的影响....     

水流作用下悬挂式防污帘有效深度数值模拟

水流与结构相互作用下的防污帘有效深度是影响其防污效果的关键因素.为探究防污帘有效深度随流速等参数的变化,基于ADINA软件动网格控制技术,结合双向流固耦合方法建立悬挂式防污帘大变形二维有限元数值模型,以分析流速、帘长及配重对防污帘有效深度的影响规律.运用防污帘变形倾角,描述悬挂式防污帘在不同负载下的变形特征,并回归拟合防污帘相对有效深度的预测经验公式.结果表明:悬挂式防污帘相对有效深度随流速增大而减小,随相对帘长与配重的增大而增大;倾角随流速与相对帘长的增大而增大,随配重的增大而减小.     

CTMAB改性蛭石对水体中对硝基苯酚的吸附研究

为提高蛭石的层间距和对有机物的吸附能力,采用阳离子表面活性剂溴化十六烷基三甲铵(CTMAB)对蛭石进行改性,并研究了其对水中对硝基苯酚的去除效果.结果显示,改性蛭石对溶液中的对硝基苯酚吸附能力明显强于原蛭石;改性蛭石对溶液中的对硝基苯酚的吸附过程在30min左右就基本达到平衡;碱性条件有利于改性蛭石吸附去除对硝基苯酚....     

造船用双角钢式脚手架的危险点电测

对角钢式脚手架进行应力测试和理论计算研究.采用电测法测试了危险截面的应力大小及分布规律.结果表明,2、4测点是危险点;采用斜弯曲理论进行理论计算,所得结论与实验测试是一致的,其中2点受拉应力作用.上述分析为脚手架的设计、制作和安全使用提供了强度分析依据.同时还对脚手架其他安全问题进行了讨论.